- 2004 EXPLORER DASHLIGHTS NOT WORKING DRIVERS
- 2004 EXPLORER DASHLIGHTS NOT WORKING MANUAL
- 2004 EXPLORER DASHLIGHTS NOT WORKING MODS
It could happen due to a loose connection of the wire or the corrosion or damage of the wire ends. If the brake light switch is functional, you have to check for a bad electrical ground (some car models have the switch provided ground). Otherwise, it will be a recurring problem. Besides, try to find out the cause of the blown fuse. Remember that the new one has to have the same amperage of the old unit. In case if the fuse is blown, change it with a new one. Any problem with the fuse box and light switch will affect the brake lights. The brake light switch is also to be found under the dashboard and check if its plunger touches the brake pedal arm. You will get the fuse panel under the dashboard and the PDC under the hood. You have to find the fuse box or the power distribution center (PDC). However, it has double filaments, allowing one set still working while the other set is burnt. In most European cars, the same bulb does the job of the tail and brake lighting. Choose the new bulbs of the same type and wattage. You need to replace bulbs if they have got darkened or the filaments are blown. Push the bulbs and turn them counterclockwise to remove from the socket.
2004 EXPLORER DASHLIGHTS NOT WORKING MANUAL
Remove the screws from the bulb lens (which you can access through the trunk or see your vehicle repair manual to get the exact location).
The possible reasons for brake lights not working but tail lights are: The Light Bulbsīlown out light bulbs are the most common reason for why the brake lights not working but the tail lights are. Sometimes, pressing the brakes turns off the tail lights too and they don’t start working again until you let the brakes off. It’s a peculiar problem since you the tail lights work fine when you drive but hitting the brake produces no response from the rear lights. The Reasons for Brake Lights Not Working but Tail Lights Are
The cops will also flag you if they see you are during without functioning lights. It can cause severe accidents, especially on dark streets or during heavy rain and snow.
2004 EXPLORER DASHLIGHTS NOT WORKING DRIVERS
If any of them does not work, other drivers behind you won’t see if you are moving or not. It is so because you won’t know what is happening in the backside while driving until someone points it out.īoth brake and tail lights are crucial for road safety. It takes a long time to notice when the brake lights not working but tail lights are or vice versa. Which in turn will power the orange wire to the instrument clusters.Driving at night with either brake lights or tail lights not working is dangerous for you and other drivers on the road. I read somewhere that the blue wire running from the headlight switch to the rheostat should be hot when the lights come on. Using a multimeter I do have 12 volts on the headlight switch (pin C thick red wire). I cleaned off all connections as much as possible to minimize any corrosion (even inside the rheostat). I tested some of the bulbs and they work as well. I have checked the fuses especially fuse 10 and they all seem to be good. Not sure if it's related, but the windshield wipers don't work. RPM gauge, speedometer, fuel, battery, etc. The instrument panel above the steering wheel that shows high beams, brake, seatbelt works. The headlights (high and low), brake lights, tail lights, blinkers all work.
2004 EXPLORER DASHLIGHTS NOT WORKING MODS
I received the jeep like this and did none of the mods myself. I have a 1990 Jeep Wrangler YJ that has a chevy 350 in it.
0 kommentar(er)
